|
|
Auteur
|
Message
|
1
|
|
|
|
bonsoir j'utilise depuis peu fédora core 7, je l'ai installé en parralelle avec xp mais j'ai un souci avec le wifi, je n'arrive pas à trouver mon reseau, le scan ne donne rien. j'utilise la freebox v4 avec une carte pcmcia fourni par free, le système fonctionne trés bien sous xp.
-->Message édité par morojo le 22/10/2007 20:12:33<--
|
|
|
|
|
bonjour, ouvre un terminal et tape: lspci
colle ici le résultat.
|
|
|
|
|
voilou
[root@localhost ~]# lspci
00:00.0 Host bridge: Intel Corporation 82P965/G965 Memory Controller Hub (rev 02)
00:01.0 PCI bridge: Intel Corporation 82P965/G965 PCI Express Root Port (rev 02)
00:1a.0 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Contoller #4 (rev 02)
00:1a.1 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Controller #5 (rev 02)
00:1a.7 USB Controller: Intel Corporation 82801H (ICH8 Family) USB2 EHCI Controller #2 (rev 02)
00:1b.0 Audio device: Intel Corporation 82801H (ICH8 Family) HD Audio Controller (rev 02)
00:1c.0 PCI bridge: Intel Corporation 82801H (ICH8 Family) PCI Express Port 1 (rev 02)
00:1c.3 PCI bridge: Intel Corporation 82801H (ICH8 Family) PCI Express Port 4 (rev 02)
00:1c.4 PCI bridge: Intel Corporation 82801H (ICH8 Family) PCI Express Port 5 (rev 02)
00:1d.0 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Controller #1 (rev 02)
00:1d.1 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Controller #2 (rev 02)
00:1d.2 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Controller #3 (rev 02)
00:1d.7 USB Controller: Intel Corporation 82801H (ICH8 Family) USB2 EHCI Controller #1 (rev 02)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev f2)
00:1f.0 ISA bridge: Intel Corporation 82801HB/HR (ICH8/R) LPC Interface Controller (rev 02)
00:1f.2 IDE interface: Intel Corporation 82801H (ICH8 Family) 4 port SATA IDE Controller (rev 02)
00:1f.3 SMBus: Intel Corporation 82801H (ICH8 Family) SMBus Controller (rev 02)
00:1f.5 IDE interface: Intel Corporation 82801H (ICH8 Family) 2 port SATA IDE Controller (rev 02)
01:00.0 VGA compatible controller: nVidia Corporation G70 [GeForce 7600 GT] (rev a1)
02:00.0 SATA controller: JMicron Technologies, Inc. JMicron 20360/20363 AHCI Controller (rev 02)
02:00.1 IDE interface: JMicron Technologies, Inc. JMicron 20360/20363 AHCI Controller (rev 02)
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 01)
05:01.0 Network controller: RaLink RT2500 802.11g Cardbus/mini-PCI (rev 01)
05:02.0 FireWire (IEEE 1394): VIA Technologies, Inc. IEEE 1394 Host Controller (rev 80)
|
|
|
|
|
|
|
|
ma carte est reconnu par le système, je connais ce tuto mais je reconnais pas comprendre grand chose
|
|
|
|
|
|
Ils disent d'ouvrir avec vi mais c'est quoi vi
|
|
|
|
|
tu ne comprends pas quoi?
que donne $ su -
# lsmod | grep ieee
# dmesg | grep rt
# lsmod
-->Message édité par niklavi le 21/10/2007 21:47:05<--
|
|
|
|
|
vi ou vim est un editeur de texte qui est excellent et qui en cas de plantage du systeme est toujours là pour te dépanner.
http://lug68.com/index.php?t=3&f=tutoriaux/vi/index.php&p=go
|
|
|
|
|
les autres ne donnent rien $ su - me dit
[root@localhost ~]# $ su -
bash: $: command not found
[root@localhost ~]# dmesg|grep 80211
[root@localhost ~]# dmesg|grep rt
ACPI: PM-Timer IO Port: 0x808
Allocating PCI resources starting at 88000000 (gap: 80000000:7ee00000)
Checking aperture...
SELinux: Starting in permissive mode
ACPI: (supports S0 S1 S3 S4 S5)
Linux Plug and Play Support v0.97 (c) Adam Belay
PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report
PCI-GART: No AMD northbridge found.
pnp: 00:08: ioport range 0x290-0x297 has been reserved
Allocate Port Service[0000:00:01.0:pcie00]
Allocate Port Service[0000:00:1c.0:pcie00]
Allocate Port Service[0000:00:1c.0:pcie02]
Allocate Port Service[0000:00:1c.3:pcie00]
Allocate Port Service[0000:00:1c.3:pcie02]
Allocate Port Service[0000:00:1c.4:pcie00]
Allocate Port Service[0000:00:1c.4:pcie02]
Linux agpgart interface v0.102 (c) Dave Jones
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
PNP: No PS/2 controller found. Probing ports directly.
serio: i8042 KBD port at 0x60,0x64 irq 1
serio: i8042 AUX port at 0x60,0x64 irq 12
hub 1-0:1.0: 2 ports detected
hub 2-0:1.0: 2 ports detected
hub 3-0:1.0: 2 ports detected
hub 4-0:1.0: 2 ports detected
hub 5-0:1.0: 2 ports detected
ehci_hcd 0000:00:1a.7: debug port 1
PCI: cache line size of 32 is not supported by device 0000:00:1a.7
ehci_hcd 0000:00:1a.7: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
hub 6-0:1.0: 4 ports detected
ehci_hcd 0000:00:1d.7: debug port 1
PCI: cache line size of 32 is not supported by device 0000:00:1d.7
ehci_hcd 0000:00:1d.7: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
hub 7-0:1.0: 6 ports detected
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
ahci 0000:02:00.0: AHCI 0001.0000 32 slots 2 ports 3 Gbps 0x3 impl SATA mode
ahci 0000:02:00.0: flags: 64bit ncq pm led clo pmp pio slum part
USB Mass Storage support registered.
kjournald starting. Commit interval 5 seconds
iTCO_vendor_support: vendor-support=0
iTCO_wdt: initialized. heartbeat=30 sec (nowayout=0)
parport_pc 00:0b: reported by Plug and Play ACPI
parport0: PC-style at 0x378 (0x778), irq 7 [PCSPP,TRISTATE,EPP]
kjournald starting. Commit interval 5 seconds
kjournald starting. Commit interval 5 seconds
|
|
|
|
|
puis
[root@localhost ~]# lsmod
Module Size Used by
sit 20585 0
tunnel4 12625 1 sit
autofs4 32841 2
hidp 38209 2
rfcomm 57961 0
l2cap 41025 10 hidp,rfcomm
bluetooth 73541 5 hidp,rfcomm,l2cap
sunrpc 191305 1
dm_mirror 30913 0
dm_multipath 28241 0
dm_mod 69169 2 dm_mirror,dm_multipath
video 27985 0
sbs 28753 0
button 17633 0
dock 19753 0
battery 19657 0
ac 14537 0
ipv6 341801 27 sit
snd_hda_intel 316513 1
snd_seq_dummy 12613 0
snd_usb_audio 98881 0
snd_seq_oss 40897 0
snd_seq_midi_event 16577 1 snd_seq_oss
snd_seq 63201 5 snd_seq_dummy,snd_seq_oss,snd_seq_midi_event
arc4 10689 2
snd_pcm_oss 52673 0
ecb 12353 2
blkcipher 15301 1 ecb
snd_mixer_oss 25537 1 snd_pcm_oss
rc80211_simple 12993 1
snd_pcm 93257 3 snd_hda_intel,snd_usb_audio,snd_pcm_oss
snd_usb_lib 26433 1 snd_usb_audio
snd_rawmidi 35137 1 snd_usb_lib
snd_seq_device 17109 4 snd_seq_dummy,snd_seq_oss,snd_seq,snd_rawmidi
snd_timer 32585 2 snd_seq,snd_pcm
snd_hwdep 19145 1 snd_usb_audio
rt2500pci 28865 0
rt2x00pci 19137 1 rt2500pci
rt2x00lib 29889 2 rt2500pci,rt2x00pci
rfkill 16465 1 rt2x00lib
input_polldev 13905 1 rt2x00lib
snd 71785 13 snd_hda_intel,snd_usb_audio,snd_seq_oss,snd_seq,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_rawmidi,snd_seq_device,snd_timer,snd_hwdep
mac80211 160081 4 rc80211_simple,rt2500pci,rt2x00pci,rt2x00lib
firewire_ohci 26945 0
cfg80211 18257 1 mac80211
eeprom_93cx6 10945 1 rt2500pci
nvidia 7016212 24
snd_page_alloc 19665 2 snd_hda_intel,snd_pcm
parport_pc 39273 0
i2c_i801 17757 0
floppy 71849 0
firewire_core 53889 1 firewire_ohci
crc_itu_t 10817 2 rt2x00lib,firewire_core
parport 48973 1 parport_pc
soundcore 17249 1 snd
i2c_core 35777 2 nvidia,i2c_i801
iTCO_wdt 20625 0
iTCO_vendor_support 12741 1 iTCO_wdt
serio_raw 16069 0
r8169 41033 0
usblp 23233 0
joydev 19905 0
sr_mod 26853 0
cdrom 44009 1 sr_mod
sg 45673 0
usb_storage 90625 0
ahci 32965 0
pata_jmicron 16065 0
ata_generic 17221 0
ata_piix 25413 4
libata 135665 4 ahci,pata_jmicron,ata_generic,ata_piix
sd_mod 37441 5
scsi_mod 168825 5 sr_mod,sg,usb_storage,libata,sd_mod
ext3 141905 3
jbd 73009 1 ext3
mbcache 18249 1 ext3
ehci_hcd 42957 0
ohci_hcd 30405 0
uhci_hcd 34401 0
|
|
|
|
|
je vais lacher pour aujourd'hui tout ça me fatigue un peu j'espère y arriver demain matin
le problème est résolu
-->Message édité par morojo le 22/10/2007 20:10:14<--
|
|
|
1
|
|
|
|
