problème de wifi [résolu]

bonsoir j'utilise depuis peu fédora core 7, je l'ai installé en parralelle avec xp mais j'ai un souci avec le wifi, je n'arrive pas à trouver mon reseau, le scan ne donne rien. j'utilise la freebox v4 avec une carte pcmcia fourni par free, le système fonctionne trés bien sous xp.

bonjour, ouvre un terminal et tape: lspci

colle ici le résultat.

voilou
[root@localhost ~]# lspci

00:00.0 Host bridge: Intel Corporation 82P965/G965 Memory Controller Hub (rev 02)
00:01.0 PCI bridge: Intel Corporation 82P965/G965 PCI Express Root Port (rev 02)
00:1a.0 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Contoller #4 (rev 02)
00:1a.1 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Controller #5 (rev 02)
00:1a.7 USB Controller: Intel Corporation 82801H (ICH8 Family) USB2 EHCI Controller #2 (rev 02)
00:1b.0 Audio device: Intel Corporation 82801H (ICH8 Family) HD Audio Controller (rev 02)
00:1c.0 PCI bridge: Intel Corporation 82801H (ICH8 Family) PCI Express Port 1 (rev 02)
00:1c.3 PCI bridge: Intel Corporation 82801H (ICH8 Family) PCI Express Port 4 (rev 02)
00:1c.4 PCI bridge: Intel Corporation 82801H (ICH8 Family) PCI Express Port 5 (rev 02)
00:1d.0 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Controller #1 (rev 02)
00:1d.1 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Controller #2 (rev 02)
00:1d.2 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Controller #3 (rev 02)
00:1d.7 USB Controller: Intel Corporation 82801H (ICH8 Family) USB2 EHCI Controller #1 (rev 02)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev f2)
00:1f.0 ISA bridge: Intel Corporation 82801HB/HR (ICH8/R) LPC Interface Controller (rev 02)
00:1f.2 IDE interface: Intel Corporation 82801H (ICH8 Family) 4 port SATA IDE Controller (rev 02)
00:1f.3 SMBus: Intel Corporation 82801H (ICH8 Family) SMBus Controller (rev 02)
00:1f.5 IDE interface: Intel Corporation 82801H (ICH8 Family) 2 port SATA IDE Controller (rev 02)
01:00.0 VGA compatible controller: nVidia Corporation G70 [GeForce 7600 GT] (rev a1)
02:00.0 SATA controller: JMicron Technologies, Inc. JMicron 20360/20363 AHCI Controller (rev 02)
02:00.1 IDE interface: JMicron Technologies, Inc. JMicron 20360/20363 AHCI Controller (rev 02)
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 01)
05:01.0 Network controller: RaLink RT2500 802.11g Cardbus/mini-PCI (rev 01)
05:02.0 FireWire (IEEE 1394): VIA Technologies, Inc. IEEE 1394 Host Controller (rev 80)

http://doc.fedora-fr.org/wiki/Installation_du_wifi_-_Ralink

ma carte est reconnu par le système, je connais ce tuto mais je reconnais pas comprendre grand chose

Ils disent d'ouvrir avec vi mais c'est quoi vi

tu ne comprends pas quoi?

que donne $ su -

# lsmod | grep ieee


# dmesg | grep rt

# lsmod

vi ou vim est un editeur de texte qui est excellent et qui en cas de plantage du systeme est toujours là pour te dépanner.

http://lug68.com/index.php?t=3&f=tutoriaux/vi/index.php&p=go

les autres ne donnent rien $ su - me dit
[root@localhost ~]# $ su -
bash: $: command not found
[root@localhost ~]# dmesg|grep 80211

[root@localhost ~]# dmesg|grep rt

ACPI: PM-Timer IO Port: 0x808
Allocating PCI resources starting at 88000000 (gap: 80000000:7ee00000)
Checking aperture...
SELinux: Starting in permissive mode
ACPI: (supports S0 S1 S3 S4 S5)
Linux Plug and Play Support v0.97 (c) Adam Belay
PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report
PCI-GART: No AMD northbridge found.
pnp: 00:08: ioport range 0x290-0x297 has been reserved
Allocate Port Service[0000:00:01.0:pcie00]
Allocate Port Service[0000:00:1c.0:pcie00]
Allocate Port Service[0000:00:1c.0:pcie02]
Allocate Port Service[0000:00:1c.3:pcie00]
Allocate Port Service[0000:00:1c.3:pcie02]
Allocate Port Service[0000:00:1c.4:pcie00]
Allocate Port Service[0000:00:1c.4:pcie02]
Linux agpgart interface v0.102 (c) Dave Jones
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
PNP: No PS/2 controller found. Probing ports directly.
serio: i8042 KBD port at 0x60,0x64 irq 1
serio: i8042 AUX port at 0x60,0x64 irq 12
hub 1-0:1.0: 2 ports detected
hub 2-0:1.0: 2 ports detected
hub 3-0:1.0: 2 ports detected
hub 4-0:1.0: 2 ports detected
hub 5-0:1.0: 2 ports detected
ehci_hcd 0000:00:1a.7: debug port 1
PCI: cache line size of 32 is not supported by device 0000:00:1a.7
ehci_hcd 0000:00:1a.7: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
hub 6-0:1.0: 4 ports detected
ehci_hcd 0000:00:1d.7: debug port 1
PCI: cache line size of 32 is not supported by device 0000:00:1d.7
ehci_hcd 0000:00:1d.7: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
hub 7-0:1.0: 6 ports detected
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
ahci 0000:02:00.0: AHCI 0001.0000 32 slots 2 ports 3 Gbps 0x3 impl SATA mode
ahci 0000:02:00.0: flags: 64bit ncq pm led clo pmp pio slum part
USB Mass Storage support registered.
kjournald starting. Commit interval 5 seconds
iTCO_vendor_support: vendor-support=0
iTCO_wdt: initialized. heartbeat=30 sec (nowayout=0)
parport_pc 00:0b: reported by Plug and Play ACPI
parport0: PC-style at 0x378 (0x778), irq 7 [PCSPP,TRISTATE,EPP]
kjournald starting. Commit interval 5 seconds
kjournald starting. Commit interval 5 seconds

puis
[root@localhost ~]# lsmod
Module Size Used by
sit 20585 0
tunnel4 12625 1 sit
autofs4 32841 2
hidp 38209 2
rfcomm 57961 0
l2cap 41025 10 hidp,rfcomm
bluetooth 73541 5 hidp,rfcomm,l2cap
sunrpc 191305 1
dm_mirror 30913 0
dm_multipath 28241 0
dm_mod 69169 2 dm_mirror,dm_multipath
video 27985 0
sbs 28753 0
button 17633 0
dock 19753 0
battery 19657 0
ac 14537 0
ipv6 341801 27 sit
snd_hda_intel 316513 1
snd_seq_dummy 12613 0
snd_usb_audio 98881 0
snd_seq_oss 40897 0
snd_seq_midi_event 16577 1 snd_seq_oss
snd_seq 63201 5 snd_seq_dummy,snd_seq_oss,snd_seq_midi_event
arc4 10689 2
snd_pcm_oss 52673 0
ecb 12353 2
blkcipher 15301 1 ecb
snd_mixer_oss 25537 1 snd_pcm_oss
rc80211_simple 12993 1
snd_pcm 93257 3 snd_hda_intel,snd_usb_audio,snd_pcm_oss
snd_usb_lib 26433 1 snd_usb_audio
snd_rawmidi 35137 1 snd_usb_lib
snd_seq_device 17109 4 snd_seq_dummy,snd_seq_oss,snd_seq,snd_rawmidi
snd_timer 32585 2 snd_seq,snd_pcm
snd_hwdep 19145 1 snd_usb_audio
rt2500pci 28865 0
rt2x00pci 19137 1 rt2500pci
rt2x00lib 29889 2 rt2500pci,rt2x00pci
rfkill 16465 1 rt2x00lib
input_polldev 13905 1 rt2x00lib
snd 71785 13 snd_hda_intel,snd_usb_audio,snd_seq_oss,snd_seq,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_rawmidi,snd_seq_device,snd_timer,snd_hwdep
mac80211 160081 4 rc80211_simple,rt2500pci,rt2x00pci,rt2x00lib
firewire_ohci 26945 0
cfg80211 18257 1 mac80211
eeprom_93cx6 10945 1 rt2500pci
nvidia 7016212 24
snd_page_alloc 19665 2 snd_hda_intel,snd_pcm
parport_pc 39273 0
i2c_i801 17757 0
floppy 71849 0
firewire_core 53889 1 firewire_ohci
crc_itu_t 10817 2 rt2x00lib,firewire_core
parport 48973 1 parport_pc
soundcore 17249 1 snd
i2c_core 35777 2 nvidia,i2c_i801
iTCO_wdt 20625 0
iTCO_vendor_support 12741 1 iTCO_wdt
serio_raw 16069 0
r8169 41033 0
usblp 23233 0
joydev 19905 0
sr_mod 26853 0
cdrom 44009 1 sr_mod
sg 45673 0
usb_storage 90625 0
ahci 32965 0
pata_jmicron 16065 0
ata_generic 17221 0
ata_piix 25413 4
libata 135665 4 ahci,pata_jmicron,ata_generic,ata_piix
sd_mod 37441 5
scsi_mod 168825 5 sr_mod,sg,usb_storage,libata,sd_mod
ext3 141905 3
jbd 73009 1 ext3
mbcache 18249 1 ext3
ehci_hcd 42957 0
ohci_hcd 30405 0
uhci_hcd 34401 0

je vais lacher pour aujourd'hui tout ça me fatigue un peu j'espère y arriver demain matin
le problème est résolu